We write, we don’t plagiarise! Every answer is different no matter how many orders we get for the same assignment. Your answer will be 100% plagiarism-free, custom written, unique and different from every other student.
I agree to receive phone calls from you at night in case of emergency
Please share your assignment brief and supporting material (if any) via email here at: email@example.com after completing this order process.
No Plagiarism Guarantee - 100% Custom Written
Motor and Machine Automation
We have a trim board = 1*4 or 1*6
all boards are white.
we need to design a machine that can do things to the board.
first thing screw some screws. on the door frame, you may have a piece of trim and the door frame about 36" up if you have a door jamb.
we could put brackets on the trim.
the board we got to stack one against another and they`re being shoved into this machine so we need to build a machine over here between the boards to stop and start the board and puts in a bracket. it might have bracket here to screw here screw there. ( same as the figure) between we need a motion control stuff. part of that we going need a coupler nip rollers (coupler, motor,..). will squeezing the board and one of them probably has a motor and one is an ipoare and we`ve got some friction right here so we can drive the boards. then registration sensor, and we need to sensor that can detect the board. then we will have basically a plate we going to amount have two screwdrivers into this plate. we need motion go up and down. and each one has to exist motor, Dc motor ( to perform better torque control in it). ( 1/2 hp brushed motor)
two screws ( 2" and .5") during travel 2.22" and 0.75"
- fix time 1.2 to driver screw
- when sensor red should move 36" and stop.
- accy +1.5mm
-cycle time 5 second.
- diameter the roller > 2.5"
- contact whole board.
- pushed with 3lb force from the beginning.
- need to take care of rolling and the tension of rolling.
- length of board 72"-90"
-force 1lb from the middle to the end.
- between the rolling can be bushed, 2 board.
- screw collaboration should be 1.2second to drive screw.
-power supply 110, 230... no limitation.
- the screwdrivers = 20lb.